Monday, May 30, 2016

Micro chisel system

Here is a special chisel clamp I made to tackle deep engraving backgrounds. 

I had to use one I had already made to chisel out the groove for the graver stock !


I can do extra narrow areas if I grind the sides of the stock down. It is a great solution to deep engravings in softer metals. 


Getting in and around raised areas can be a challenge with a large graver. Visibility is obscured and there is a greater risk of damaging areas with the backside of the graver. 


Here removing background around a fox that is 2mm tall!! 


Nine thousands of an inch wide! 

Ray Hyder toolmaker ,artist 

No comments:

Post a Comment